Gear Pump with Out Motor is required by a Pakistan customer. The melt pump specifications and other requirement advised by customer as the following details.

Extrusion gear pump types include gear metering pumps for PUR, adhesives, resins, coatings, paint; Spinning Pumps; Spinfinish Metering Pumps; Discharge Pumps & Pressure Increase Pumps; etc.

The simplex systems can be provided with either fixed or removable vessels; a compact preheat station with spare vessel can be provided for locating near the line for quick change out.

Batte supplies two melt pumps (gear pumps) for a company producing cuspated sheets and drainage geocomposites. A capacity of 300-350 kg / h pump and a capacity of about 500kg / h pump are required.

Dosing pumps are widely used for industry. Batte supplies the following pumps for a customer from Korea. The specifications and technical details are introduced for more customers who need this type pump.

Extrusion line synchronization made easy. With high pressure gear pumps between your extruder and die you can directly dial in gauge control, eliminating extruder surge and screw beat at the die.

Gear pump pressure control is so important that a poor control algorithm for the pump can cause some variation in the extruder screw speed, causing large variations in the inlet pressure to the pump.

A gear pump is a common method to decrease the discharge pressure from the extruder, especially if the discharge pressure required by the die is relatively high. Temperature reduction and surge suppression are factors.

Screenchangers for blown film extrusion are continuous screen changers recommended for blown film filtration. A two bolt or piston design is usually preferred as shown in the following pictures.

Gear pump for compact rubber extruder adopts advanced cutting-edge extrusion technology, and consists of pump body, driving shaft, sliding bearing, front plate, and with labyrinth sealing.